UMFT200XD - Development breakout module for the FT200XD IC

The UMFT200XD Breakout Module provides the most cost-effective and simplest development hardware for the FT200XD USB to I2C interface IC.

The UMFT200XD is a breakout board that converts USB2.0 Full-Speed to I²C. These modules do not have a USB connector - instead the modules plug directly into the USB host connector and the pads of the PCB makes electrical contact with the electrical contacts of the USB connector.

The I²C interface operates at +3.3V voltage levels, however all I/Os are 5V tolerant.

  • USB to I2C with four control bus lines
  • 3.3V power out limited to 50mA and 5V with as safety fuse
  • Upgrading Legacy Peripherals to USB
  • Utilising USB to add system modularity
  • Incorporate USB interface to enable PC transfers for development system communication
  • Motherboard and system monitoring through USB
  • USB dongle implementations for Software/ Hardware Encryption and Wireless Modules
  • Interfacing MCU/PLD/FPGA based designs to add USB connectivity
  • USB Instrumentation
  • USB Industrial Control
  • USB Digital Camera Interface
  • Capable of detecting dedicated USB charger ports for charging batteries with high current
Part Number Description Pack Size
UMFT200XD USB to I²C with four control bus lines, 3.3V power out limited to 50mA and 5V with as safety fuse. I²C signals available via 8 pin female connector. Each
UMFT200XD-NC USB to I²C with four control bus lines, 3.3V power out limited to 50mAand 5V with as safety fuse. I²C signals available via 8 pads on the PCB Each
UMFT200XD-WE USB to I²C with four control bus lines, 3.3V power out limited to 50mA and 5V with as safety fuse. I²C signals available via 8, 6" flying leads connected to the PCB pads. Each
FT200XD-R 10-pin DFN Single chip USB to I²C interface IC Reel of 5000
FT200XD-T 10-pin DFN Single chip USB to I²C interface IC
Tray of 490

Related Products

Recently Viewed Products

Last updated: 9 October 2012