The USB 2.0 Hi-Speed to MPSSE cable contains a small internal
electronic circuit board, utilising the FTDI FT232H, which is
encapsulated into the USB connector end of the cable, this handles
all the USB signalling and protocols. The cable provides a
fast, simple way to connect devices with 3.3 Volt digitalinterfaces
to USB.
The integrated FT232H device incorporates a command processor
called the Multi-Protocol Synchronous Serial Engine (MPSSE).
The purpose of the MPSSE command processor is to communicate with
devices which use synchronous protocols (such as JTAG, SPI or
I2C) in an efficient manner. Full details are available in the
MPSSE application note - AN_108.
The cable is terminated by ten individual wires with single pole
connectors which can be interfaced to a male header. Cable
signals are compliant with CMOS logic at 3.3 volts.
- Based on the Single chip USB Hi-Speed FT232H device
- USB 2.0 Hi-Speed (480Mbits/Second) and Full Speed
(12Mbits/Second) compatible
- Entire USB protocol handled on the chip -No USB-specific
firmware programming required
- USB Type A connector for direct connection to a host or
hub
- USB bus powered
- Fully assisted hardware or X-On / X-Off software
handshaking
- Synchronous Serial (MPSSE) data rates of up to 30Mbps on
JTAG, SPI and I2C
- 1kByte receive and transmit buffers for high data
throughput
- Transmit and receive LED drive signals
- Adjustable receive buffer timeout
- Support for USB suspend and resume
- Low operating and USB suspend current
- Low USB bandwidth consumption
- UHCI / OHCI / EHCI host controller compatible
- -40°C to +85°C operating temperature range
- Cable length is 0.5m (19.7 inch)
- Custom versions also available (subject to Minimum Order
Quantity (MOQ))
- FTDI's royalty-free D2XX drivers eliminate the requirement
for USB driver development in most cases
- USB to JTAG interfaces
- USB to SPI interfaces
- USB to I2C interfaces
- Interfacing MCU / PLD / FPGA based designs to USB
- USB Audio and Low Bandwidth Video data transfer
- Rapid USB integration into existing electronic
systems
- Prototyping platform for USB interface on new systems
- USB Instrumentation
| C232HM-DDHSL-0 |
USB to MPSSE cable with +3.3V digital level signals. Maximum
data rate 30Mbps. Single pole, receptacle x 10. 0.5m long. |
| C232HM-EDHSL-0 |
USB to MPSSE cable with +5V digital level signals. Maximum data
rate 30Mbps. Single pole, receptacle x 10. 0.5m long.
|
